Network service is the most likely problem

Network service is the most likely problem 


On a VLSM network, which mask should you use on point-to-point WAN links in order to reduce the waste of IP addresses?

A. /27

B. /28

C. /29

D. /30

E. /31

 

·         D. A point-to-point link uses only two hosts. A /30, or 255.255.255.252, mask provides two hosts per subnet.

 

 

To use VLSM, what capability must the routing protocols in use possess?

A. Support for multicast

B. Multiprotocol support

C. Transmission of subnet mask information

D. Support for unequal load balancing

 

·         C. To use VLSM, the routing protocols in use possess the capability to transmit subnet mask information.

 

If Host A is configured with an incorrect default gateway and all other computers and the router are known to be configured correctly, which of the following statements is TRUE?

A. Host A cannot communicate with the router.

B. Host A can communicate with other hosts in the same subnet.

C. Host A can communicate with hosts in other subnets.

D. Host A can communicate with no other systems.

 

·         B. With an incorrect gateway, Host A will not be able to communicate with the router or beyond the router but will be able to communicate within the subnet.

 

Which of the following troubleshooting steps, if completed successfully, also confirms the other steps will succeed as well?

A. ping a remote computer

B. ping the loopback address

C. ping the NIC

D. ping the default gateway

 

·         Pinging the remote computer would fail if any of the other tests fail.

 

When a ping to the local host IP address fails, what can you assume?

A. The IP address of the local host is incorrect.

B. The IP address of the remote host is incorrect.

C. The NIC is not functional.

D. The IP stack has failed to initialize.

 

·         C. When a ping to the local host IP address fails, you can assume the NIC is not functional.

 

What network service is the most likely problem if you can ping a computer by IP address but not by name?

A. DNS

B. DHCP

C. ARP

D. ICMP

 

·         The most likely problem if you can ping a computer by IP address but not by name is a failure of DNS.

 

When you issue the ping command, what protocol are you using?

A. DNS

B. DHCP

C. ARP

D. ICMP

 

·         D. When you issue the ping command, you are using the ICMP protocol.

 

Which of the following commands displays the networks traversed on a path to a network destination?

A. ping

B. traceroute

C. pingroute

D. Pathroute

 

·         B. The traceroute command displays the networks traversed on a path to a network destination.

 

What command generated the output shown below?

Reply from 172.16.10.2: bytes=32 time<1ms TTL=128
Reply from 172.16.10.2: bytes=32 time<1ms TTL=128
Reply from 172.16.10.2: bytes=32 time<1ms TTL=128
Reply from 172.16.10.2: bytes=32 time<1ms TTL=128
A. traceroute

B. show ip route

C. ping

D. Pathping

 

·         C. The ping command tests connectivity to another station. The full command is shown below.


C:\>ping 172.16.10.2
Pinging 172.16.10.2 with 32 bytes of data:
Reply from 172.16.10.2: bytes=32 time<1ms TTL=128
Reply from 172.16.10.2: bytes=32 time<1ms TTL=128
Reply from 172.16.10.2: bytes=32 time<1ms TTL=128
Reply from 172.16.10.2: bytes=32 time<1ms TTL=128
Ping statistics for 172.16.10.2:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms

 

Which of the following network addresses correctly summarizes the three networks shown below efficiently?

10.0.0.0/16

10.1.0.0/16

10.2.0.0/16

A. 10.0.0.0/15

B. 10.1.0.0/8

C. 10.0.0.0/14

D. 10.0.0.8/16

 

·         C. The interesting octet in this example is the second octet, and it is a block size of four starting at 10.0.0.0. By using a 255.252.0.0 mask, we are telling the summary to use a block size of four in the 2nd octet. This will cover 10.0.0.0 through 10.3.255.255. This is the best answer.

 

What command displays the ARP table on a Cisco router?

A. show ip arp

B. traceroute

C. arp -a

D. Tracert

 

·         The command that displays the ARP table on a Cisco router is show ip arp.

 

What switch must be added to the ipconfig command on a PC to verify DNS configuration?

A. /dns

B. -dns

C. /all

D. Showall

 

·         C. The /all switch must be added to the ipconfig command on a PC to verify DNS configuration.

 

Which of the following is the best summarization of the following networks: 192.168.128.0 through 192.168.159.0

A. 192.168.0.0/24

B. 192.168.128.0/16

C. 192.168.128.0/19

D. 192.168.128.0/20

 

·         C. If you start at 192.168.128.0 and go through 192.168.159.0, you can see this is a block of 32 in the third octet. Since the network address is always the first one in the range, the summary address is 192.168.128.0. What mask provides a block of 32 in the third octet? The answer is 255.255.224.0, or /19.

 

Answer Detail

Get This Answer

Invite Tutor